Tamiya Big Netz

Long time ago decided I wanted to convert the Tamiya 1/32 F-16CJ Block 50 Falcon into an IDF F-16A Netz. Fast forward and with the ability to design and print to a good standard now, means I finally have everything I need to finish this model, so onwards.

In flight, so set up the pose for the jet using some square-section brass tube
 

 

Early conversion work
 

 

 

 

 

Netz antennae design finished and attached

 

 

 

And the bolt on chaff/flare dispensers. Not fitted to tail yet as still rescribing the Hasegawa tail base
 

 

And a new seamless exhaust so no nasty internal seams to clean up, and added detail to the nozzle inner section
 

 

 

Very nice work as always Craig.
On a side note I'm going to be setting an area for Vendors to "advertise" their products and wares, you of course will be welcome to post your stuff. It's a free service and it will initially just be a section of the forums. Would be good to see your stuff in there.

MOST envious of you 3d designers. Such cool stuff and opens a world of possibilities like this. Looking great!